Randy's Transmission BabyMaker1000 68RFE BILLET Valve Body 07.5-18 Cummins

This is the SAME valve body we use in ALL our 68RFE transmissions!

Eliminate cross leaks, increase line / holding pressure, and have better peace of mind!

The valve body is flat sanded to exact tolerances. Randy's installs HD billet accumulators proven to prevent bore wear and provides unsurpassed sealing qualities. Sonnax accumulator plate cover with 3 additional bolts eliminating plate blowout. SSV is reamed out and Transgo switch valves are installed to correct wear and leaks. All valve body bores are vacuum tested to insure hydraulic integrity. HD billet channel plate is installed onto the valve body and torqued to our specifications preventing cross leaks which results in premature transmission failure.

Includes new O.E solenoid block.

THIS WILL NOT FIX A TRANSMISSION WITH RATIO CODES. IF YOU'RE EXPERIENCING THIS ISSUE, THE TRANSMISSION IS HURT. 

Will Fit With OE Transmission Pan

To unlock the full potential of the Babymaker, it requires trans tuning. 

If you do not have tuning, this will, at minimum eliminate cross leaks. You MUST email us if you do not plan to tune your truck to get additional information!!!

THIS IS THE INFORMATION YOUR TUNER WILL NEED TO PROPERLY TUNE FOR THE BABYMAKER:

-LINE PRESSURE SET TO 225PSI ABOVE 30% THROTTLE ANGLE
-100PSI RESTING PRESSURE
-NO LOCKUP UNTIL 4TH GEAR
-LOW/REVERSE SPRAG HOLDOUT

Core charge is fully refunded upon receipt of complete, rebuildable core valve body assembly.